Forums de discussion
Pressure drop in PipeNet
Vous devez être connecté pour répondre
| Auteur | Message |
|---|---|
| SuperPiper
Membre |
Posté le 17/12/2023 à 01:18:04
Hello! 🙂I have another question. How do you add a pressure drop in a pipe? |
| TheLibrarian
**Modérateur** |
Posté le 17/12/2023 à 11:23:44
Hi!In PIPENET, like in other fluid flow software, you can add a pressure drop in different ways. It depends on what you are trying to model. For example, you can use an orifice plate, a valve, a general pressure loss component, a fitting and so on. There are also other components which generate a pressure drop. It really depends on what you are trying to model. If you want more details about the components I mentioned, check out the manual. 😉 -------------------------- 
|
| SuperPiper
Membre |
Posté le 17/12/2023 à 11:42:04
I want to modl an heat exchanger.
|
| TheLibrarian
**Modérateur** |
Posté le 17/12/2023 à 11:46:59
In that case, you could use either the heat exchanger component or add a fitting. But check out the manual because the heat exchanger is not available in all modules of PIPENET. If it is not available, you can only use a fitting attached to pipe.
--------------------------
|
| SuperPiper
Membre |
Posté le 17/12/2023 à 11:50:35
ok thanks.I understand 🙂 |
Vous devez être connecté pour répondre
Partager cette page sur les réseaux sociaux :
